Job Description
Job DescriptionDescription:
Summary Job Description: Responsible for final finishes running machine. This involves tasks related to set-up, machine operation, and disposing of chips as required.
Shift: 8 hours regular shifts and 12 hours over-time shifts. Breaks: 30 minute lunch. Flooring: Cement, wooden platforms, grates, rubber mats. Environment: Machine shop environment. Need to be careful with other employees while moving overhead cranes in the vicinity. Safety Equipment: Hard hat, gloves, safety glasses, and steel-toe shoes. Strength Range: Medium-Heavy strength range.
Tools and Equipment: Roll grinder, various hand tools, chip pushers, cranes, shovels, brooms, etc. This list is not all inclusive.
Job Functions and Functional Job Task Elements
Task 1: Operate Machine
- Receive metal rolls from machine area-a jib crane can be used to lift heavier items.
- Check prints for specific job.
- Parts placed and measurements taken and tool marked prior to running job.
- Need a forward reach of 32”.
- Gripping of parts and tools.
- May need to utilize drivers to operate the machine-can weigh up to 90#.
- Change out bearings as needed.
- Must monitor machine operation carefully due to close tolerance of machine operation-final finishes on neck and barrel.
- Trunk flexion and twisting.
- May utilize stool for sitting if needed to observe and monitor machine while running.
- Walk back and forth to monitor machine.
- Visual inspection of part.
Task 2: Maintain Machine and Surrounding Area
- The chips on this machine need be shoveled into pit.
- Oil/water mix with -soda ash.
- Check machine for maintenance: check fluids, etc.
- Complete time sheet per job: materials and time noted.
- Keep area clean, sweep, pick up debris, etc.
Job Analysis Summary Sheet
United Rolls Inc.
Job Title: Roll Grinder
Essential Job Functions, Frequency/Duration Operate Machine Maintain Machine/ Area
Material Handling
Floor to Waist 10-90# Up to 30#
Waist to Shoulder
Shoulder to Overhead
Pushing/Pulling At least 50# of force At least 25# of force
Carry 10-90# 30#
Positional Tasks
Standing/Walking F O
Sitting O O
Neck
Bending/Flexion O-F O
Extending “ “
Twisting “ “
Side Bending “ “
Back
Bending/Flexion O O
Extending “ “
Twisting “ “
Side Bending “ “
Upper Extremity
Right Hand Gripping Mx Mx
Left Hand Gripping Mx Mx
Fine Manipulation O-F O
Repetitive Motion O O
Reaching O O
Overhead Activity
Lower Extremity
Walking O O
Squatting I-O I
Kneeling
Climbing O O
Balancing “ “
N: Negligible R: Rare I: Infrequent O: Occasional F: Frequent C: Constant
Less than 1% 1% or less of task 2-5% of task 6-33% of task 34-66% of task 67-100% of task
1 or less reps/hour 1-2 reps/hour 3-12 reps/hour 13-30 reps/hour 31-60 reps/hour
1 or less reps/day 2-20 reps/day 21-100 reps/day 101-245 reps/day 246-490 reps/day
Mn: (Minimal) Below 30% of Maximum Force Mx: (Maximal) Exceeding 30% of Maximum Force
Requirements: